CurrentFeed = GetOemDRO(818)	'Save the current feed settings
DoSpinStop()	'Spindle stopped

Cur = GetDro(0) 'Reading x coordinate
Move = Cur-20.0 'Maximum detection depth 20.0
Offset = Abs(GetOEMDRO(1000))/(2) 'Radius edge finder to compensate out
Sal = Offset + 2.0 'After the completion of the knife, leaving the workpiece 2.0

If GetOemLed (825)=0 Then	'To judge the edge finder whether there is contact with the workpiece? Only in the beginning there is no contact with the workpiece, can run to search edge
Code "G4 P2.5"	'Pause 2.5 seconds
Code "G31 X"& Move & "F25"	'x-axis to find the edge as the feed rate of 25
While IsMoving()		'Wait stop searching edge detector
Sleep(200)
Wend
Probepos = GetDro(0)		'
Call SetDro(0, Offset)		'Set the new x-origin
Code "G4 P1"			'Pause
Code "G0 X" & Sal		'Fall back
Code "(X zeroed)"		'Prompt Message
Code "F" &CurrentFeed 		'Restore the original feed settings

Else
Code "(Check Ground Probe)"	'Edge finder (probe) is shorted to ground the (contact with the workpiece), abort the operation
End If

Exit Sub