Agilent U3606A Firmware Revision History ---------------------------------------------- IOB - IO Board MB - Measurement Board SB - Source Board Release 03.07(IOB)-04.07(MB)-03.02(SB) (9-Jan-2013): - Improved GPIB timeout on looping test. - Improved NI LabView driver issue. - Corrected VOLT:ACDC:RANGE? MAX and MEAS? command - Resolved GPIB Legacy issue. - Resolved USB NI driver issue. - Resolved the IOB firmware update issue on IOB version 2.00 Release 03.00(IOB)-04.00(MB)-03.00(SB) (14-Mar-2012): - Resolved MEAS:VOLT? AUTO,MIN command issue - Resolved GPIB timeout issue & CR+LF issue - Resolved the IOB firmware update issue. (format new flash IC to 256 bytes per page) Improved from version 02.00(IOB)-03.00(MB)-03.00(SB) & 02.01(IOB)-03.00(MB)-03.00(SB) Release 02.03(IOB)-03.01(MB)-03.00(SB) (9-Dec-2011): - Resolved the IOB firmware update issue. (format new flash IC to 256 bytes per page) - Resolved GPIB issue Release 02.02(IOB)-03.01(MB)-03.00(SB) (18-Nov-2011): - Resolved the IOB firmware update issue. (format flash IC to 256 bytes per page) - Resolved CR issue on GPIB - Resolved Utility save issue Release 02.01(IOB)-03.00(MB)-03.00(SB) (9-Jun-2011): - Resolved the IOB firmware update issue. Release 02.00(IOB)-03.00(MB)-03.00(SB) (23-Mar-2011): - To improve the CC mode Trip issue (involved hardware changes) - To improve the CC stability issue on E-load CV & CR Release 02.00(IOB)-02.00(MB)-02.01(SB) (18-Nov-2010): - To clear the Error511 - "Current output over protection" in display Release 02.00(IOB)-02.00(MB)-02.00(SB) (20-May-2010): - To add 20mV range in DMM. - To add in Smooth Function in DMM. - To add in Source Protection Mode with ON/OFF. - To add in the termination :\n detection. Release 01.00(IOB)-01.00(MB)-01.00(SB) (14-Oct-2009): - To improve the Low Resistance measurement time. - To enhance the device clear execution. - To enhance the queue up buffer for continuously sending write commands without read back. - Resolved the wrong range returned while set to default range in duty cycle voltage measurement. - Resolved the subsequence query commands timeout after the time consuming measurement if purposely shorten the timeout setting. Release 00.18(IOB)-00.50(MB)-00.21(SB) (20-May-2009): Initial release.